Industrial battery & solar powered lights made in Nottingham, UK. For skips, fences, scaffolding, bulkheads & hoardings

@
CLOSE

Sales Line

0115 840 4144

Sales Line: Mon-Thur 0900-1530, Fri 0900-1200

Status News: Check Lead times here

Thank you for using JC Multilight

Thank you for using one of our products.

A security Key is provided to access the lights with your order.

Lights operate Dusk til Dawn with a daylight sensor (Photocell).

Our daylight sensors ensure that the lights turn on in low light and preserve battery during the daytime.

If your light isn’t turning ON it could mean that there is already sufficient light. 

If your light isn’t turning OFF, it could be that there is insufficient daylight.

In an office environment, artificial light does not always provide the correct wavelengths. If the light is not turning off, take it outside in broad daylight.

All Lights come with Batteries Included – We sell replacement batteries if required. 

Below are some guides on how to use our lights and change batteries.

 

If you require any more assistance please visit Our FAQ’s page OR email sales@multilight.co.uk

(all prices ex-VAT)

Category:

HOARDING LIGHTS

By using the front security key provided with the delivery note for your order, you can remove the polycarbonate lens and use the switch provided to put the light into the desired operation. Flashing, Off or Continuous.
To replace the batteries, use a Pozi-head screwdriver to loosen the 4xM4 screws holding the electronics in place. (please keep the washers on these screws in place)
You can then lift the electronics out and replace the 4xD-Type batteries. Secure the electronics back onto the 4 pillars and test the operation before fastening the polycarbonate lens.

D1 is the Daylight sensor. You may have to cover this up to simulate the low light required for the light to come on.

LITTLE JOHN LIGHTS

By using the front security key provided with the delivery note for your order, you can remove the Front lens by loosening the three M6 screws.
To replace the batteries, simply take the front lens, along with the electronics out of the enclosure and swap the Lithium Battery, making sure that it is the correct polarity.

D1 is the Daylight sensor. You may have to cover this up to simulate the low light required for the light to come on.

SKIP LIGHTS

By using the front security key provided with the delivery note for your order, you can remove the Front lens by loosening the two M6 screws.
To replace the batteries, unscrew the battery pack from the ‘inner’ chassis, remove the foam pad and replace the C-Type batteries. please note; the foam pad is important to add back on top of your new batteries to avoid any short-circuit.

D1 is the Daylight sensor. You may have to cover this up to simulate the low light required for the light to come on.

Related products